When configuring Cisco Secure ACS to support wireless EAP authentication,which device mustbeconfigured as a AAA client?()
时间:2022-10-10
You review the Failed Attempts logs on an AAA server and find: "unknown network access servererror." Which failure could produce this error?()
Given a bridge link 6 miles (9.7 km) long,which parameter on the root radio interface page must be configured in order for ip traffic to pass?()
时间:2022-10-09
When conducting an Assisted Site Survey, the WLSE does which of the following during the Radio Scan process?()
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch, and on power-up the access point fails. What is the problem with the switch?()
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations. What is the maximum number of WLAN controllers that you can add?()
时间:2022-10-08
装用普通行星齿轮差速器的汽车,当一个驱动轮陷入泥坑时,汽车难于驶出的原因是()
On the wlse, which of the following fault policies would be used to verify that access to the command-line interface of the access point is secure?()
You are using adu and are authenticated and associated to an access point. you are unable to obtain an ip address. Which of the following will cause this problem?()
时间:2022-10-07
When setting an access point to a non-root role,what two parameters,other than role in the radio network, must be configured on the ssid manager page?()
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off. What does this indicate?()
Using the wlse,you are trying to push out a configuration job to an access point,but the job does not start. Which of the following would cause this failure?()
On a standalone access point, client association using EAP-Cisco Wireless (Cisco-LEAP) is failing,but association using EAP-PEAP is functioning. What needs to be enabled on the standalone accesspoint to correct this issue?()
时间:2022-10-06
When conducting an assisted site survey, the wlse does which of the following during the radio scan process?()
When setting an access point to a non-root role, what two parameters,other than Role in theRadio Network,must be configured on the SSID Manager page?()