You are trying to deploy a configuration job to an ios access point using the wlse, but the job fails. Which of the following would cause this failure?()
时间:2022-10-28
Select the wireless service component in the implement phase in which operations responsibilities are defined and transferred to the operate phase team.()
A rogue access point is detected on the cisco wcs consolE. upon investigation,the access point is discovered to belong to a neighboring business. Your administrator should designate the rogue access point as which of the following?()
During the installation of the Cisco WCS, an error occurs. Where will the installation log be found?()
时间:2022-10-27
A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24PWR Switch. However, when it is powered up, the access point fails. What has caused this problem?()
On a Cisco Aironet 1130AG Series standalone access point, the status LED is dark blue and blinking. What does this indicate?()
Which of these statements is true about ssids configured in cisco adu?()
The IOS of a North American Cisco Aironet 1230 Series access point has become corrupt, necessitating the need for a TFTP firmware reload. Before you press and hold the MODE button,what must the file be named in order for the reload to occur?()
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network,but clients using PEAP are failing to log on. Which situation would result in thistype ofproblem?()
时间:2022-10-26
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it,which continue to pass traffic. What has causedthis problem?()
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2. H-REAP AP2 has six other clients associated to it, which continue to pass traffic. What has caused this problem?()
A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24 PWRSwitch. However, when it is powered up, the access point fails. What has caused this problem?()
When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges. Which of the following rts threshold and cwmin settings would be correct for the non-root bridges?()
时间:2022-10-25
On a standalone access point, client association using EAP-Cisco Wireless (Cisco-LEAP) isfailing, but association using EAP-PEAP is functioning. What needs to be enabled on the standalone accesspoint to correct this issue?()
When installing a Cisco WCS, which two ports can be changed during installation?()