Which two file types must be included in a closed database backup taken with operating system commands?()
Which two locations can be configured as a source for the IOS image in the boot system command?()
While creating a scheduler window using the DBMS_SCHEDULER package, a user logged in as DBMGR gets the error message insufficient privileges. Which two commands would you use to resolve this error?()
Which command will result in a trace file being created with the create controlfile command contained in it?()
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()
You are a senior network administrator at TestKing, and while performing thepassword recovery procedure on your 2500 series Cisco router, you type in thefollowing command:o/r 0x2142What is the purpose of this command?()
Which command can be used on a PE router to connect to a CE router (11.1.1.4) in VRF red?()
While applying a service update on a system using SMIT, the system administrates SMIT Command Status screen shows "Command: failed". Which of the following procedures should be performed to investigate the failure?()
Which two operations are NOT performed by the DUPLICATE command in Recovery Manager (RMAN) while duplicating a running database?()
Which command is used to begin a tablespace point-in-time recovery?()
Which set of commands is recommended to prevent the use of a hub in the access layer?()
You want to create a temporary table while executing a procedure in a form. Which statement is true?()
In a TCP/IP network, which of the following protocols is involved when a user issues a ping command?()
While logged into a router, you wish to see the RIP routing updates in real time as they are sent and received. Which command would you issue to see these updates?()
Which command displays only those entries in a BGP table with specific AS_PATH attributes?()
Communication with a remote host has failed. Which command is LEAST helpful in isolating the failure?()
Which command is used to determine if a host has logged in to the Fibre Channel fabric? ()
While creating a scheduler window using the DBMS_SCHEDULER package, a user logged in as DBMGR gets the error message insufficient privileges? Which two commands would you use to resolve this error?()
Which command should an administrator use to put a system in maintenance mode without rebooting?()
Which command must be run to log a hardware repair entry in the errorlog?()
Which command will result in a trace file being created with the create controlfile command contained in it?()
Which command retrieves and displays information about each Cisco product in the form of a UDI? ()
While you are on watch entering port,the Master gives the helmsman a rudder command which conflicts with a rudder command from the Pilot.You should make sure the helmsman().
In a Bridged 1483 network, which set of commands is used to configure an ATM subinterface?()