A router receives a packet on interface 172.16.45.66/26. The source IP of the packet is 172.16.45.127/26 and the destination is 172.16.46.191/26.How will the router handle the packet?()
A . The destination is a host on another subnet, so the router will not forward the packet.
B . The destination is a host on the same subnet, so the router will forward the packet.
C . The destination is a broadcast address, so the router will not forward the packet.
D . The destination is a network address, so the router will forward the packet.
-
For best packet switching performance with crypto, what is the recommend packet switching path in a Cisco Teleworker Router?()
A . Process Switching
B . Silicon Switching
C . Cisco Express Forwarding (CEF) Switching
D . Autonomous Switching
-
A router receives information about network 192.168.10.0/24 from multiple sources.What will the routerconsider the most reliable information about the path to that network?()
A . an OSPF update for network 192.168.0.0/16
B . a static router to network 192.168.10.0/24
C . a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
D . a RIP update for network 192.168.10.0/24
E . a directly connected interface with an address of 192.168.10.254/24
F . a default route with a next hop address of 192.168.10.1
-
Choose two commands that are required to enable multicast on a router, when it is known that the receivers use a specific functionality of IGMPv3.()
A . ip pim rp-address
B . ip pim ssm
C . ip pim sparse-mode
D . ip pim passive
-
There is MPLS VPN traffic traversing through a TE intermediate router. What is the MPLS packet labelstack sequence (from outer to inner) for the VPN traffic on this router?()
A . TE label, IGP label, VPN label
B . IGP label, TE label, VPN label
C . TE label, VPN label, IGP label
D . VPN label, IGP label, TE label
E . IGP label, VPN label, TE label
-
If the router R1 has a packet with a destination address 192.168.1.255, what describes the operation of the network()。
A . R1 will forward the packet out all interfaces.
B . R1 will drop this packet because this it is not a valid IP address.
C . As R1 forwards the frame containing this packet, Sw-A will add 192.168.1.255 to its MAC table.
D . R1 will encapsulate the packet in a frame with a destination MAC address of FF-FF-FF-FF-FF-FF
E . As R1 forwards the frame containing this packet, Sw-A will forward it to the device assigned the IP address of 192.168.1.255.
-
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
A . an OSPF update for network 192.168.0.0/16
B . a static router to network 192.168.10.0/24
C . a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
D . a RIP update for network 192.168.10.0/24
E . a directly connected interface with an address of 192.168.10.254/24
F . a default route with a next hop address of 192.168.10.1
-
Refer to the exhibit. A packet with a source IP address of 192.168.2.4 and a destination IP address of 10.1.1.4 arrives at the HokesB router. What action does the router take?()https://assets.asklib.com/images/image2/2018072315292175903.jpg
A . forwards the received packet out the Serial0/0 interface
B . forwards a packet containing an EIGRP advertisement out the Serial0/1 interface
C . forwards a packet containing an ICMP message out the FastEthernet0/0 interface
D . forwards a packet containing an ARP request out the FastEthernet0/1 interface
-
A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network?()
A . a directly connected interface with an address of 192.168.10.254/24
B . a static route to network 192.168.10.0/24
C . a RIP update for network 192.168.10.0/24
D . an OSPF update for network 192.168.0.0/16
E . a default route with a next hop address of 192.168.10.1
F . a static route to network 192.168.10.0/24 with a local serial interface configured as the next ho
-
Which two commands are required to enable multicast on a router, knowing that the receivers only support IGMPv2?()
A . ip pim rp-address
B . ip pim ssm
C . ip pim sparse-mode
D . ip pim passive
-
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU?()
A . It will fragment the packet at Layer 2.
B . It will fragment the packet at Layer 3.
C . It will drop the packet and send an ICMPv6 message "packet too big" back to the source.
D . It will drop the packet.
-
What IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link?
-
What field in IP packet is prevent the packet from a route to router forever?
-
Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link? ()
A . anycast address
B . site-local multicast
C . global address of the link
D . unique local address
E . link-local addre
-
What is the recommended Cisco DSCP value for a switch or router passing Cisco Unified Wireless IP Phone 7921G RTP packets?()
A . CS3
B . CS1
C . EF
D . 5
E . 6
-
A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network()。
A . a directly connected interface with an address of 192.168.10.254/24
B . a static route to network 192.168.10.0/24
C . a RIP update for network 192.168.10.0/24
D . an OSPF update for network 192.168.0.0/16
E . a default route with a next hop address of 192.168.10.1
F . a static route to network 192.168.10.0/24 with a local serial interface configured as the next ho
-
A network administrator receives an error message while tring to configure the Ethernet interface of a router with IP address 10.24.24.24/29.which statement explains the reason for this issue?()
A . The address is a broadcast address
B . The Ehernet interface is faulty
C . VLSM-capable routing protocols must be enable first on the router.
D . This address is a network address.
-
Which two commands are required to enable multicast on a router, knowing that the receivers only supports IGMPv2?()
A . IP PIM RP-address
B . IP PIM ssm
C . IP PIM Sparse-mode
D . IP PIM Passive
-
What method in a Cisco IOS router can confirm that packets marked for a particular QoS marking are being matched?()
A . Issue a show policy-map interface command.
B . Assuming Netflow is enabled, issue a show ip cache verbose flow command.
C . Issue a show crypto ipsec session command.
D . Issue a debug qos set command and a terminal monitor command.
-
After attempting to telnet into a router, you are denied and you receive the error message "password required, but none set." What configuration changes will allow telnet access into this router?()
A .https://assets.asklib.com/images/image2/2018073013554218805.jpg
B .https://assets.asklib.com/images/image2/2018073013554875867.jpg
C .https://assets.asklib.com/images/image2/2018073013555890653.jpg
D .https://assets.asklib.com/images/image2/2018073013560739765.jpg
-
A host on the LAN is accessing an FTP server across the Internet. Which of the following addresses could appear as a source address for the packets forwarded by the router to the destination server()。
A . 10.10.0.1
B . 10.10.0.2
C . 199.99.9.33
D . 199.99.9.57
E . 200.2.2.17
F . 200.2.2.18
-
Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link?()
A . anycast address
B . site-local multicast
C . global address of the link
D . unique local address
E . link-local addre
-
What is the OSPF default frequency,in seconds,at which a cisco router sends hello packets on a multi-access network?()
A . 10
B . 40
C . 30
D . 20
-
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?()https://assets.asklib.com/images/image2/2018072408541982136.jpg
A . 10.1.1.2
B . 10.1.2.2
C . 10.1.3.3
D . 10.1.4.4
-
The router receives a login request from a PPP over ATM client and examines the domain map for the client‘s domain. The router finds no entries currently configured within the domain map.What does the router do with the login request?()
A. The router rejects it.
B. The router tunnels it via L2TP.
C. The router authenticates it locally.
D. The default virtual router authenticates it.