-
A router simultaneously receives all the following routes in various routing updates. Which of thefollowing routes would end up in the routing table?(Choose all that apply.)()
A . RIP route 10.1.2.0/24
B . EIGRP route 10.1.2.0/24
C . RIP route 10.1.0.0/16
D . OSPF route 10.1.0.0/16
E . RIP route 10.0.0.0/16
F . OSPF route 10.1.2.0/24
-
Policy -Based Routing (PBR) has been enabled on Router R1's interfa ce F0/0. Which of the following is true regarding how PBR works?()
A . Packets entering F0/0 will be compared based on the PBR route map.
B . Packets exiting F0/0 will be compared based on the PBR route map.
C . IOS ignores the PBR forwarding directions wh en the packet matches a route map deny clause.
D . IOS ignores the PBR forwarding directions when the packet matches a route map permit clause.
-
The tag timeout value for a cisco wireless location appliance should be set to which tag beacon rate?()
A . 4 to 6 times the tag beaconing rate
B . 10 to 12 times the tab beaconing rate
C . 8 to 10 times the tag beaconing rate
D . 6 to 8 times the tag beaconing rate
-
Users on the 192.168.1.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server?()
A . ip route 0.0.0.0 0.0.0.0 s0/0/0
B . ip route 0.0.0.0 0.0.0.0 209.165.200.226
C . ip route 209.165.200.0 255.255.255.0 192.168.1.250
D . ip route 192.168.1.0 255.255.255.0 209.165.100.250
-
Refer to the exhibit. The company uses EIGRP as the routing protocol. What path will packets take from a host on 192.168.10.192/26 network to a host on the LAN attached to router R1?()https://assets.asklib.com/images/image2/2018072410123247953.jpg
A . The path of the packets will be R3 to R2 to R1.
B . The path of the packets will be R3 to R1 to R2.
C . The path of the packets will be both R3 to R2 to R1 and R3 to R1.
D . The path of the packets will be R3 to R1
-
Which command will display all the EIGRP feasible successor routes known to a router?()
A . Router# show ip eigrp routes *
B . Router# show ip eigrp summary
C . Router# show ip eigrp topology
D . Router# show ip eigrp adjacencies
E . Router# show ip eigrp neighbors detail
-
Which series of commands will configure router R1 for LAN-to-LAN communication with router R2? The enterprise network address is 192.1.1.0/24 and the routing protocol in use is RIP.()https://assets.asklib.com/images/image2/2018072315342863428.jpg
A . R1(config)# interface ethernet 0;R1(config-if)# ip address 192.1.1.129 255.255.255.192;R1(config-if)# no shutdown
B . R1(config)# interface ethernet 0;R1(config-if)# ip address 192.1.1.97 255.255.255.192;R1(config-if)# no shutdown
C . R1(config)# interface serial 0;R1(config-if)# ip address 192.1.1.4 255.255.255.252;R1(config-if)# clock rate 56000
D . R1(config)# interface serial 0;R1(config-if)# ip address 192.1.1.6 255.255.255.252;R1(config-if)# no shutdown
E . R1(config)# router rip;R1(config-router)# network 192.1.1.4;R1(config-router)# network 192.1.1.128
F . R1(config)# router rip;R1(config-router)# version 2;R1(config-router)# network 192.1.1.0
-
Users on the 192.168.1.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server()。
A . ip route 0.0.0.0 0.0.0.0 s0/0/0
B . ip route 0.0.0.0 0.0.0.0 209.165.200.226
C . ip route 209.165.200.0 255.255.255.0 192.168.1.250
D . ip route 192.168.1.0 255.255.255.0 209.165.100.250
-
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network()。
A . The router will use the static route.
B . The router will use the OSPF route.
C . The router will use the EIGRP route.
D . The router will load balance and use all three routes.
-
Under what two circumstances is the set JspBody method NOT called in a tag class that implements the Simple Tag interface? ()
A . The tag is invoked without a body.
B . The doTAb method throws an exception.
C . The
-
Which routing protocol best fits these requirements?() - Supported by multiple router vendors - Requires minimum router CPU and memory resources - Uses a simple routing metric - Supports manual or automatic route summarization
A . EIGRP
B . OSPF
C . IS-IS
D . RIPv2
-
Which routing protocol best fits these requirements?() - Supported by multiple router vendors - Requires minimum router CPU and memory resources - Uses a simple routing metric - Supports manual or automatic route summarization
A . EIGRP
B . OSPF
C . IS-IS
D . RIPv2
-
hat two things will a router do when running a distance vector routing protocol?()
A . Send periodic updates regardless of topology changes.
B . Send entire routing table to all routers in the routing domain.
C . Use the shortest-path algorithm to the determine best path.
D . Update the routing table based on updates from their neighbors.
E . Maintain the topology of the entire network in its database.
-
Router R1, in ASN 11, learns a BGP route from BGP peer R22 in ASN 22. R1 and then uses BGP to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP table on R2 for this route?()
A . 22
B . 11
C . 1
D . None
-
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()
A . For the two vlans to communicate,a network statement for the trunk interface needs to be added to the OSPF configuration.
B . For the two vlans to communicate, a network statement for each subinterface needs to be added to the OSPF configuration.
C . Direct inter-vlan communication does not require OSPF
D . OSPF cannot be used if router-on-a-stick is configured on the router
-
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?()
A . Metric
B . Administrative distance
C . Timeout (seconds)
D . Prefix length
E . Interface ID
-
What two things will a router do when running a distance vector routing protocol?()
A . Send periodic updates regardless of topology changes.
B . Send entire routing table to all routers in the routing domain.
C . Use the shortest-path algorithm to the determine best path.
D . Update the routing table based on updates from their neighbors.
E . Maintain the topology of the entire network in its database.
-
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?()
A . The router will use the static route.
B . The router will use the OSPF route.
C . The router will use the EIGRP route.
D . The router will load balance and use all three routes.
-
Which command will configure a default route on a router?()
A . router(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1
B . router(config)# ip default-route 10.1.1.0
C . router(config)# ip default-gateway 10.1.1.0
D . router(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
-
Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3?()
<img src='https://img2.soutiyun.com/ask/uploadfile/2019-03-27/c0432bed5e96b27cf201162a3a16be20.png' />
A. 10.0.0.0/8
B. 172.16.10.0/24
C. 172.16.0.0/24
D. 10.10.10.0/24
E. 172.16.0.0/16
F. 10.10.0.0/16
-
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0".Whic h of the following is most likely to have caused this output to occur on R1?()
A. R1 has been configured with an ip default- network 2.0.0.0 command.
B. R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.
C. R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
D. Another router has been configured with an ip default - network 2.0.0.0 command.
E. Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
-
Which two static routes are typically configured on your router when a Routed 1483 network is grouping ATM PVCs intoalarge subnet?()
A.host route
B.default route
C.customer network
D.ISP’s routing domain
-
根据网络拓扑和需求说明,完成(或解释)路由器R1的配置。 Router(config) ipv6 unicast-routing(3)
根据网络拓扑和需求说明,完成(或解释)路由器R1的配置。
Router(config) ipv6 unicast-routing (3)
Rl(config) interface Serial 1/0
R1(config-io (4) address (5) (6) (设置串口地址)
R1(config-if)no shutdown (开启串口)
R1(config)interface FastEthemet0/0
R1(config-if) (7) address (8) (设置以太口地址)
R1(config-if)exit
(3)
-
Router R1 learns two routes with BGP for prefix 200.1.0.0/16. Comparing the two routes, route 1 has a shorter AS_Path Length, smaller MED, the same Weight, and smaller Local PreferencE.Which of the following is true about Router R1‘s choice of best path for this prefix?()
A. Route 1 is the best route.
B. Route 2 is the best route.
C. The routes tie as best, but one will be picked to be placed in the routing table based on tiebreakers .
D. Neither route is considered best.