-
When configuring role-based CLI on a Cisco router,which action will be taken first ?()
A . Create a parser view called "root view."
B . Log in to the router as the root user.
C . Enable the root view on the router.
D . Enable role-based CLI globally on the router using the privileged EXEC mode Cisco IOS command.
-
What is a design consideration when using existing PCIe I/O drawers in a maximum bandwidth/throughput configuration on a new Power 750 system?()
A . The new system requires 1 installed processor card for the GX++ bus adapter
B . The new system requires a minimum of 2 installed processor cards for the GX++ bus adapter
C . The new system requires a minimum of 3 installed processor cards and the HPC InfiniBand cluster adapter
D . The new system requires 1 installed processor card for the GX++ bus adapter and the HPC InfiniBand cluster adapter
-
Which parameter, when enabled on a standalone access point, gives the highest priority to a voice packeteven when QoS is not enabled?()
A . QoS Element for Wireless Phones
B . IGMP Snooping
C . WMM
D . AVVID Priority Mapping
-
What is one of the reasons that custom QoS ACLs are recommended over automatic QoS when configuring ports on a Catalyst 6500 for use with IP phones?()
A . 79xx IP phones do not automatically mark voice packets with non-zero DSCP values.
B . 79xx IP phones do not mark protocol packets such as DHCP, DNS, or TFTP with non-zero DSCP values.
C . 79xx IP phones do not mark voice packets with optimal DSCP values.
D . 79xx IP phones use a custom protocol to communicate CDP information to the switch.
-
What are three of the functions that AutoQoS performs when it is configured on a switch?()
A . synchronizes FIFO, PQ, CQ, and MDRR, with WFQ, CBWFQ, and LLQ
B . enables strict priority queuing for voice traffic, and weighted round robin queuing for data traffic
C . enables low latency queuing to ensure that voice traffic receives priority treatment
D . enforces a trust boundary on switch access ports and uplinks/downlinks
E . modifies queue sizes as well as queue weights where required
F . adjusts link speeds to adapt to QoS need
-
Which three QoS mechanisms can be configured to improve VoIP quality on a converged network?()
A . The use of a queuing method that will give VoIP traffic strict priority over other traffic
B . The use of RTP header compression for the VoIP traffic.
C . The proper classification and marking of the traffic as close to the source as possible
D . The use of 802.1QinQ trunking for VoIP traffic
E . The use of WRED for the VoIP traffic
-
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
A . The crypto ACL number
B . The IPSEC mode (tunnel or transport)
C . The GRE tunnel interface IP address
D . The GRE tunnel source interface or IP address, and tunnel destination IP address
E . The MTU size of the GRE tunnel interface
-
When configuring a wireless LAN controller for QoS, what 802.1p tag should be applied for video applications? ()
A . 3
B . 1
C . 4
D . 6
-
When configuring a serial interface on a router, what is the default encapsulation?()
A . atm-dxi
B . frame-relay
C . hdlc
D . lapb
E .
-
When a new trunk link is configured on an IOS based switch, which VLANs are allowed over the link?()
A . All defined VLANs are allowed on the trunk by default.
B . Each VLAN, or VLAN range, that is specified with the switchport mode command.
C . Each VLAN, or VLAN range, that is specified with the vtp domain command.
D . Each VLAN, or VLAN range, that is specified with the vlan database command.
-
Which of these best describes the actions taken when a VTP message is received on a switch configured with the VTP mode "transparent"? ()
A . VTP updates are ignored and forwarded out all ports.
B . VTP updates are ignored and forwarded out trunks only.
C . VTP updates are made to the VLAN database and are forwarded out trunks only.
D . VTP updates are ignored and are not forwarded.
-
When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link?()
A . no VLANs
B . all VLANs
C . only VLANs 1 - 64
D . only the VLANs that are specified when creating the trunk
-
Which of the general policies on the wlan edit page on the wlan controller would be used when configuring a radio for a single antenna for an outdoor application?()
A . 802.11b/g
B . radio
C . access point
D . 802.11a
-
When HSRP is configured on a network, which two of these items are provided, which are sharedbetween the routers that run HSRP? ()(Choose two.)
A . TCP-based hello packets
B . the impact of flapping links if timers are too low
C . a shared single interface
D . the ability to track serial interfaces
E . UDP-based hello packet
-
When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link()。
A . no VLANs
B . all VLANs
C . only VLANs 1 - 64
D . only the VLANs that are specified when creating the trunk
-
When configuring port security on a Cisco Catalyst switch port, what is the default action taken by the switch if a violation occurs? ()
A . protect (drop packets with unknown source addresses)
B . restrict (increment SecurityViolation counter)
C . shut down (access or trunk port)
D . transition (the access port to a trunking port)
-
Which two statements correctly identify factors to consider when Configuring WAN QoS?()
A . Voice Traffic uses Assured Forwarding
B . Voice Signaling traffic uses Assured Forwarding
C . Voice Signaling traffic uses priority queuing
D . Voice Traffic uses priority queuing
E . Voice signaling traffic should use priority queuing with Assured Forwarding
-
Which of the general policies on the WLAN edit page on the WLAN controller would be used when configuring a radio for a single antenna for an outdoor application?()
A . 802.11b/g
B . radio
C . access point
D . 802.11a
-
What s the default stratum clock on a Cisco router,when you see the key word "master" configured on the NTP line?()
A . 1
B . 2
C . 4
D . 6
E . 8
-
When CONFIGURE CONTROLFILE AUTOBACKUP is set to ON, RMAN automatically performs a control file autobackup in which three situations?()
A . At the end of every RUN block.
B . After every SET CONTROLFILE AUTOBACKUP FORMAT command.
C . After every BACKUP or COPY command issued at the RMAN prompt.
D . At the end of every RUN block if the last command in the block was either BACKUP or COPY.
E . Whenever a BACKUP or COPY command within a RUN block is followed by a command that is neither BACKUP nor COPY.
F . After every BACKUP or COPY command within a RUN block that is followed by the CONFIGURE CONTROLFILE AUTOBACKUP FORMAT command.
-
When configuring a routed port on a Cisco multilayer switch, which of these is a required configuration task that you must perform to enable that port to function as a routed port? ()
A . Enable the switch to participate in routing updates from external devices with the router command in global configuration mode.
B . Enter the no switchport command to disable Layer 2 functionality at the interface level.
C . Each port participating in routing of Layer 3 packets must have an IP routing protocol assigned on aperinterface level.
D . Routing is enabled by default on a multilayer switch, so the port can become a Layer 3 routing interface by assigning the appropriate IP address and subnet information.
-
When configuring unified ports on a 5548 switch, which port ordering must be respected?()
A . Fibre Channel ports must be configured from the first port in the module.
B . Ethernet ports must be configured from the last port in the module.
C . Fibre Channel ports must be configured from the last port in the module.
D . Ethernet ports must be configured from the first port in the module.
-
Which two static routes are typically configured on your router when a Routed 1483 network is grouping ATM PVCs intoalarge subnet?()
A.host route
B.default route
C.customer network
D.ISP’s routing domain
-
Click the Exhibit button.When configuring WXC A‘s local WAN parameters, which QoS network parameter would you choose?()
<img src='https://img2.soutiyun.com/ask/uploadfile/2019-03-27/7a3e04e05d324bd96ad245b89b3b2356.jpg' />
A. over-subscribed
B. under-subscribed
C. dedicated circuits
D. nondedicated circuits