Which two protocols are used by bridges and/or switches to prevent loops in a layer 2 network?()
On switch R1 you issue the "udld enable" global command. What does this command accomplish? ()
What can a network administrator utilize by using PPP Layer 2 encapsulation (Choose three.) ()。
Distribution layer: This layer includes LAN-based routers and layer 3 switches . When is a first-hop redundancy protocol needed in the distribution layer?()
As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the devicE.For what two reasons can this happen? ()
You need make configuration changes to an existing layer 3 switch in the Company network. On a multilayer Catalyst switch, which interface command is used to convert a Layer 3 interface to a Layer 2 interface?()
In a switched environment, what does the IEEE 802.1Q standard describe?()
Which three statements accurately describe layer 2 Ethernet switches?()
While logged into a Company switch you issue the following command: CompanySwitch(config-mst)# instance 10 vlan 11-12 What does this command accomplish?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
What are two advantages of Layer 2 Ethernet switches over hubs?()
What are some common layer 2 encapsulations for a WAN link?()
What layer of the TMN (telecommunications management network) model does CTM fit into?()
A customer is deploying a wireless core feature set using autonomous access points and requires Layer 2 roaming. What is a requirement when deploying this solution?()
What can a network administrator utilize by using PPP Layer 2 encapsulation? (Choose three.)()
If an enterprise customer required A switch for their branch office access layer, which family of switches would the customer likely choose from?()
What are two advantages of Layer 2 Ethernet switches over hubs?()
As a frame leaves a Layer 3 device,the Layer 2 encapsulation information is changed from what it was when it entered the device. For what two reasons can this happen?()
Which command alone will disable trunking on a Layer 2 switch port?()
What benefit results from implementation of Layer 3 switching versus Layer 2 switching in a fully meshed campus network?()
A new Company switch was just configured using the "switchport trunk native vlan 7" command. What does this interface command accomplish?()
Which three statements accurately describe layer 2 Ethernet switches?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?() https://assets.asklib.com/images/image2/2018073109320145794.jpg
If an enterprise customer required a switch for their branch office access layer, which family of switches would the customer likely choose from?()