What are the default values for GRE tunnel keeplive time and number of retries?()
我们可以用PTN3900的POD41单板的接口作(),可以承载的tunnel类型有()
当网管业务配置完成后,对Tunnel和业务下配置时操作步骤为()
由于Virtual-template、Dialer、Tunnel等接口是虚拟的接口,因此这些接口不加入到域中也可以正常收发报文。()
What are the header sizes for point-to-point and multi-point GRE(also known asmGRE) with tunnel key?()
Refer to the exhibit. https://assets.asklib.com/images/image2/2018073016070377463.png Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel?()
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
配置业务时tunnel标签值必须大于(),配置业务时VPWS中的出入PW标签值必须不小于()。
在某路由器上执行displa interface tunnel显示GRE隧道接口的信息如下,从上述信息可以得知()。https://assets.asklib.com/images/image2/2017080110453552135.jpg
为保证MPLS TE Tunnel正确建立,以下关于MPLS TE Tunnel接口的配置说法正确的是()。
A GRE tunnel is configured between a local and a remote site. Where should the service policy be applied to classify packets based on the pretunnel header? ()
在GRE Tunnel接口视图下,配置隧道封装模式为GRE的完整命令为()。
网管业务配置完成后,对Tunnel和业务下配置时操作步骤为()。
两台ME60直接互联配置GREtunnel,tunnel接口网络协议UP,但Router1的Tunnel1/0/0与Router2的Tunnel1/0/0之间无法互相ping通,请列出可能的原因
在GRE Tunnel接口视图下,配置Keeplive报文的发送周期为10s,判断隧道中断所需要的Keeplive报文的传送次数为3,命令为()。
Which two mechanisms can be used to detect IPsec GRE tunnel failures?()
在创建静态tunnel时,需要指定下一跳的接口,显示的下一跳的地址是().
Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?()https://assets.asklib.com/images/image2/2018073016420757032.jpg
MSAP中EOS板卡上,要将交换端口设置为ACCESS和TRUNK时必须关闭USE-CORE-TAG配置,要将交换端口设置为trunk double-tagging和dot1q-tunnel时必须开启USE-CORE-TAG配置。不执行可能出现业务不通的情况。
在PTN产品中,以下哪些类型的接口可以用作网络侧承载tunnel?()
在PTN配置Tunnel的时候可以通过()避免主备同路由
标准GRE协议配置时,虚拟Tunnel接口的源端、目的不一定要为公网IP地址()
可以用PTN3900的POD41单板的接口作(),可以承载的tunnel类型有()。
防火墙在运行GRE时,tunnel接口必须配置下面哪几个参数?()