-
Which of the listed failures, occurring in an automated diesel generator system, should cause an audible alarm at the engine room control station?()
A . Low cooling water outlet temperature
B . High lube oil pressure
C . Low lube oil temperature
D . Low starting air pressure
-
在核动力厂设计中必须考虑发生共因故障的可能性,并尽实际可能采取适当的措施,如应用(),使共因故障的影响降低到最小程度。
A . 单一故障准则
B . 故障安全设计
C . 多重性
D . 多样性
E . 独立性
-
A system administrator notices that one of the mirrored disks, hdisk7 on datavg, has had a hardware failure. What is the best method of recover without causing additional problems?()
A . unmirrorvg datavg hdisk7 reducevg datavg hdisk7 replace the physical volume, run cfgmgr extendvg datavg hdisk7 mirrovg datavg hdisk7
B . varyoffvg datavg Rmdev -l hdisk7 -d Replace the physical volu,e run cfgmgr The system will automatically remirror when the disk is replaced
C . unmirrorvg datavg hdisk7 rmdev -l hdisk7 - d replace the physical volume, run cfgmgr extendvg datavg hdisk7 The system will automatically remirror when the disk is replaced.
D . unmirrorvg datavg hdisk7 reducevg data hdisk7 rmdev -l hdisk7 -d replace the physical volume, run cfgmgr extendvg datavg hdisk7 mirrovg datavg
-
The most common diesel engine fuel system problems are caused by ().
A . incorrect adjustments
B . dirty fuel
C . broken fuel lines
D . excessive vibratio
-
You are trying to deploy a configuration job to an IOS access point using the WLSE, but the jobfails. Which of the following would cause this failure?()
A . SNMP communities
B . Telnet/SSH user/password
C . WLCCP credentials
D . HTTP user/password
-
Banks have no liability for any delay or loss caused by postal or telex failure.
A . 正确
B . 错误
-
In the common rail system, excessive pressure in the header may be caused by ()
A . improper adjustment of the bypass valve
B . a dribble in the fuel injection nozzle
C . insufficient leak-off through injection nozzle packing
D . a malfunctioning injection nozzle
-
Electrical failures in motors are caused by the breakdown of insulation, which may be caused by ()
A . penetration of moisture
B . accumulation of dirt
C . overheating
D . All of the above
-
Burner ignition failure in an automatically fired auxiliary boiler would be caused by()
A . a burned out solenoid in the oil supply valve
B . high temperature excess air
C . incorrectly setting the hot-well dump valve
D . an incorrectly positioned burner snubber realy
-
核动力厂若干同类型部件同时失效时,也可能发生共因故障。这可能由()原因所引起。
A . 环境条件的变化
B . 信号饱和
C . 重复的维修差错
D . 设计缺陷
E . 人为事件
-
The major cause of anchor buoy pendant wire failures is().
A . corrosion
B . rough weather
C . defective sockets
D . mishandling
-
Using the WLSE, you are trying to push out a configuration job to a standalone access point, butthe job does not start. Which of the following would cause this failure?()
A . invalid parameter in the template
B . incorrect SNMP communities on the access point
C . pop-up blocker enabled in the browser
D . unsupported version of IOS firmware in the access point
-
Which of the following is not considered a common approach to narrow the field of potentialproblem causes? (Choose the best answer.)()
A . Following the traffic path
B . Top-down
C . Comparing configurations
D . Bottom-up
E . Divide and conquer
F . Examine SLA
-
Hydraulic machinery failures are commonly caused by contamination of the hydraulic fluid and ().
A . fluid friction
B . fluid turbulence
C . component misalignment
D . pressure surge
-
Refer to the exhibit,a network administrator cannot establish a telnet session with the indicated router.What is the cause of this failure?()
A . A level 5 password is not set
B . The vty password is missing
C . The console password is missing
D . An ACL is blocking Telnet acce
-
Which of the following is not considered a common approach to narrow the field of potential problem causes()
A . Following the traffic path
B . Top-down
C . Comparing configurations
D . Bottom-up
E . Divide and conquer
F . ExamineS LA
-
You are trying to deploy a configuration job to an ios access point using the wlse, but the job fails. Which of the following would cause this failure?()
A . snmp communities
B . telnet/ssh user/password
C . wlccp credentials
D . http user/password
-
构筑物,系统和部件的可靠性设计,可以通过防止共因故障,()和采用故障安全设计等来实现。
A . 单一故障准则
B . 多重性
C . 多样性
D . 独立性
E . 以上4种方法
-
Advection fog is most commonly caused by ______.
-
The most common cause of stree is usually a ___1_____ of things rather than___2____.
-
The most common linking words or expressions of cause & effect include:
-
Our failure __________ourselves to modem life often causes us trouble in our work.
A. to adopt B. to apply
C. to adapt D. to act
-
《核动力厂设计安全规定》规定:在设计中尽实际可能采取()措施,使共因故障的影响降低到最低程度。
A.多重性
B.多祥性
C.独立性
D.以上三者均可
-
为减少其些共因故障,可采用()原则,从而提高某些系统的可靠性。
A.多重性
B.多样性
C.独立性
D.故障安全